vManage unhide command

[navidn]

Hello,

As I was trying to push vManage (version 20.7.1) templates for vManage itself, I lost connectivity to the GUI interface and currently, I am not able to configure vpn0 and interfaces again because template overwrites itself. So, I need to go round the "is_vmanaged" state and configure the device via CLI.

Apparantly, there was a "unhide vipteal_internal" available for disabling "is_vmanaged" state which I can not find it in recent version.

I would be appreciated if anyone can help me through these situation.

[Lei Tian]

Hello,

Try this, see if it works in 20.7?

vmanage# request support is-vmanaged disable
“is-vmanaged successfully disabled”
HTH,

Lei Tian

[svemulap@cisco.com]

hi Navidn -

Starting 20.4, unhide support has been taken out.
Please Checkout: https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvx23574

Have added:
vEdge: request support is-vmanaged [disable|enable] cEdge: request platform software sdwan is-vmanaged [disable|enable] [configure 'sevice internal' if is not seen]

Hope it helps.

[navidn]

Thanks for your answer,

Unfortunately, it does no apply on vManage and the CLI configuration can not be commited. Should I deploy vManage from the ground again?

[svemulap@cisco.com]

Which version the vManage is running ?

Feel free to open a TAC Case if you need assistance.

[navidn]

vManage 20.7.1

As my vManage is running on my LAB environment I am not entiteled with any service contract to use Cisco TAC.