We followed the instructions for creating a tunnel from fortigate to secure access. However, the status of the tunnel is still disconnected. Just also wanted to ask—does this setup apply if the use case is for remote access VPN (users connecting remotely), and not for traffic from on-prem users going through IPSec? If so, the source IP we entered in FortiGate policy is VPN subnets that are also added to the VPN IP Pool in cisco secure access. But based on the documentation, even before setting policy, it should be established for a few minutes which didn't happen. Does anyone experience this kind of scenario?
For the policy, based on the documentation, the destination is all. Can we set the destination only for server apps (private resources) or specific IP address only and the source IP is the VPN subnet?
