How long does a Network Module (netmod) take to go to Hardware Bypass mode, and come out of Hardware Bypass mode?
The following table provides a guideline for hardware bypass time (relay switching time) of a network module (netmod) on a Sourcefire appliance. Please note that these are only the hardware relay switching times and do not include any software delays.
Typical Relay Switching Time
Maximum Relay Switching Time
Multi Mode Fiber
2x10G Short Range (SR), 4x1G Fiber, 40G Fiber Netmod etc.
Hello,I'm working with our networking team to get 802.1x EAP-TLS authentication working. It has been successful so far with many of the machines that we've been testing. However, I received a message stating that one of the networking laptops was trying t...
Doing upgrade of Ironport C300V in a two node cluster.upgrading from 12.1.0 to 12.5.1 build 37disconnected nodes from cluster as usual, first node failedfirst attempt but worked second attempt.second node failes all the times with:Removing unwanted ...
Dear Team, I have new cisco firepower 2120 asa and i can acess https and asdm via default management port and IP address(192.168.45.1)I have set inside interface address with address 10.x.x.x and allow https/asdm but cannot access via this interface,...
can someone assist me why is showing private cloud during integration AMP with FMC Last login: Tue Feb 18 10:16:42 UTC 2020Server: 188.8.131.52Address: 184.108.40.206#53Non-authoritative answer:api.amp.sourcefire.com canonical name = api-vpc-1125033044.us-...
Hi, Yes I saw, some people just made the rate high, then there is no warning... is there a table from Cisco about the Rate nummer for the right device? we have installed the Firepower 4115, welch nummer should I configure? regards&nb...