To access Cisco router with CCP following steps are required.
Connect to your router using console and configure it for Telnet and SSH.
Configure SSH and Telnet for local login and privilege level 15.
Enable the router's HTTP or HTTPS server.
Create a user with privilege level 15.
Discover the router with CCP.
Router(config)# line vty 0 4 Router(config-line)# privilege level 15 Router(config-line)# login local Router(config-line)# transport input telnet Router(config-line)# transport input telnet ssh Router(config-line)# exit Router(config)# ip http server Router(config)# ip http secure-server Router(config)# ip http authentication local Router(config)# username <username> privilege 15 password 0 <password>
Once Router is configured, launch CCP from your PC add new router and discover it. Refer to following screen shots:-
Dear all. we use network discovery and it works as expected. But today we faced interesting issue. When i looked at x.x.x.x ip's identity, it shows that current user is TOM, but we are sure that TOM's ip address is y.y.y.y. when we look at y.y.y.y it show...
Hi,I would like to ask about multi-auth.I want to run 802.1x wired authentication. i have 2960 switch port ge0/1 connected to dump switch port ge 0/1. All hosts and printer are connect to other port of dump switch .I want to run 802.1x on 2960 port.I want...
We have 2 VPNs and two, almost, identical PCs. One VPN called myaccess, second - OCNA.On first machine OCNA VPN works fine, on second - all server/resource names begin un-resolvable via DNS(but any IP's are pingable).Difference between two situation is me...
This topic is a chance to clarify your questions about Cisco Threat Response, from its components and new features to the resources to get started. During the session, the Threat Response team will answer questions about how Cisco Threat Response can...