cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

How To Enable SNMP On FirePower Using FDM

3093
Views
30
Helpful
8
Comments

The attached document will guide you through configuring SNMP on a FirePower device using FDM. 

Comments
Martin L
VIP Advocate

Thanks for sharing!

robinson
Enthusiast

Thanks for Sharing the write up.

Steveo2000
Beginner

Hey, just want to ask you if you could also explain how to enable SNMP via FDM  (Cisco Firepower 1010) 6.7.

With 6.7 there is no FlexConfig for SNMP anymore and you have to use the REST API and this is nether

documented anywhere, nor are there any tutorials for SNMP configurations via API. This is ridiculously complicated.

 

BR

Steve

Marcello75
Beginner

Hi, how to config the snmp via FDM using 6.7?

Anupam Pavithran
Cisco Employee

I'm using 6.7 version and I'm having the same issue

davebush
Cisco Employee

Please note that my documentation only works on version 6.6 and prior. (I've used it as far back as version 6.4.) 

 

For version 6.7 or newer you will need to use @Anupam Pavithran's script from this posting. 

 

https://community.cisco.com/t5/security-documents/firepower-device-manager-fdm-6-7-snmp-using-python-script/tac-p/4290136#M7147

 

My FP1010 is on 6.7.0 now, and thanks to Anupam I'm able to get SNMP data into my Stealthwatch Enterprise system. 

ga.hernandez
Beginner

I am using FDM on 6.6. My snmp server is located on MGMT interface. I am able to access my FTD GUI using the HTTPS to MGMT IP address; I tried to use the flex config but I got an error, seems like Management1/1 is not an interface, the error disappeared when I used "diagnostic" interface but snmp is not responding yet. What could be wrong?

 

Content for Community-Ad