To participate in this event, please use the button to ask your questions
This topic is a chance to clarify your questions about Cisco Threat Response, from its components and new features to the resources to get started. During the session, the Threat Response team will answer questions about how Cisco Threat Response can simplify complex threat investigations in order to improve incident response in these ways:
Coordination of activities among Firepower, Umbrella, AMP, Email Security, Threat Grid, and Talos in order to improve threat hunting efficiency
Reduced adversary dwell times through rapid responses from AMP and Umbrella from a unified response console, in as little as two clicks
Simplified access and module configuration
Ask questions from Tuesday 18th to Friday 21st of February, 2020
Ben Greenbaum is a Technical Marketing Engineer with over twenty years of experience in the Cyber Threat Intelligence field, primarily in the realm of product design and development. His security software career has included roles that span development, architecture, product design, and management of research and development teams. At Cisco, his role is largely to be a liaison between customers and engineering, and to help users get the most from the Cisco Security architecture.
Ben might not be able to answer each question due to the volume expected during this event. Remember that you can continue the conversation on the Security category.
Hi can anyone help me with this please? I'm having a hard time configuring the site to site vpn connection. Basically I'm just following instruction on some tutorials and videos, still I can't configure the connection to our ASA. Our network admin just re...
aaa new-modelradius-server localnas 192.168.51.175 key 0 ciscouser test password testuser testa password test When I create a local radius server I am unable to test it with the free radius tool radtestfreeRadius:~# radtest -t pap test test 192.168.5...
routingHello,For some reason I am not able to each peer's IP, though port channel and their subs are up. Arista [eth5]====[gi4]Cisco CSR ping 10.248.100.5Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 10.248.100.5, timeout is 2 ...
I have an issue where I am trying to connect a Win10 machine using AnyConnect with Posture module and I am getting a certificate error stating it doesn't trust the cert assigned to my ISE admin node. The client provisioning portal loads (https://fqdn:8443...
unable to connect I am getting the following debug information? SA KE N NOTIFY(IKEV2_FRAGMENTATION_SUPPORTED) NOTIFY(NAT_DETECTION_SOURCE_IP) NOTIFY(NAT_DETECTION_DESTINATION_IP) VID VID VID VID*May 14 15:17:05.067: IKEv2:(SESSION ID...