Hello,
I am currently setting up a few switches and one configuration point is to secure acccess via telnet from only certain IP's
I have created the access list as shown below :
access-list 20 permit 192.168.1.0 0.0.0.255
access-list 20 permit 10.44.1.2
And sh line shows 0 - 15 VTY lines
And then apply this using the syntax below :
en
conf t
line 0 15
access-class 20 in
end
wr
This then results in the below output :
switch1#sh run | beg line vty
line vty 0 4
access-class 20 in
password 7 xxx
line vty 5 14
access-class 20 in
password xxx
line vty 15
password xxx
As you can see it only appears that 0 4, then 5 - 14 are protected and line 15 does not have the applicable access list applied
Any help at all would be greatly appriciated
Cheers