Network Security

Dear Folks,Recently we had purchase, NAC Manager, Nac Server, Nac VPN and Nac Profiler. If any one can provide a little push in right direction, to Implement right scenario in an Enterprise Network for Remote access VPN, through SSL VPN on ASAMuch Ap...

HiHope you can help, my basic problem is that we have recently added a second outside interface with a new IP range and over a few months I will have to migrate our traffic to the new outside interfaceAt the moment the origonal outside Int has the de...

whether its possible to initate Phase 1 tunnel with selected  TCP service port number instead of allowing all TCP service port with peer IP address .For Example : isakmp enable outsideisakmp policy 10 encryption 3desisakmp policy 10 hash md5iaskmp po...

My internal IP address range is due to be changed from 172.x.x.x net to 10.x.x.x net in March, in which not enough time to migrate my systems and access. Is there a NAT/PAT solution in which requests to internal hosts can be translated to 10.x.x.x ho...

Hi, I have seen various posts relating to this issue but I still can't resolve this, all I want to do it to allow an XP machine to connect to a remote PPTP VPN Server.I have a zone firewall set up on my 877 and configured "inspect pptp" and also allo...

Hi guys,we want to automate the firmware and asdm file upload to our ton of ASAs but I can't find out the specifics.I want to mimic ASDM which does a https post to fqdn/admin/disk0/filename-on-flash.I found out that 'Content-Length' in the http heade...

Hello--   I recently implemented the IPS that is built in the Advanced Security IOS on a 2811 router. Can I manage it with the Cisco IPS Manager Express 7.0.2? I want to be able to manage and run reports.cjw

i got a task to configure Catalyst 6509 supervisor engin sup720-10g-3c  and has FWSM and IDSM-2 service modules .what consideration should i take  and is  there is any configuration example for boththank you for your help

Hi Experts,             We have 2ASA and each one have AIP-SSM,with 2nd ASA AIP-SSM I tried to upload latest image for AIP-SSM 20 but didnt worked and now i see module is dead...pls check the detials below.....pls help me out how to make it up or wor...

Hi all ,I have 2 ASA configured in active/standby failover mode. I want to configure IPS in promiscus mode with fail-open configuration.i have not connected IPS with any pc through magmt port.I can access IPS through ASA(5520) using session 1 and abl...

I am running IME version 7.0.2 on Windows 2003 Server, however it was found that everytime I logout the desktop (Locally, not Remote desktop) the windows IME service "Cisco IPS Manager Express" will terminated automatically. I have try to fresh insta...