Splunk version 4.2 was required for SplunkforIronportWSA v1. I haven't been able to find a suggestd version for v2 of the WSA app. Has that been published by Cisco?
Hello, SInce the patch of our ISE platform 2.6 from patch 7 to 8 , SMS sending to guest is not working. Unfortunately, I'm not able to find any logs or reports to troubleshout the issue. I just see the error message from sponsor portal :&nb...
view more
Hello, I'm looking for help in creating an ipsec between a dlink dwr-925 and a cisco ASA. On the dlink I've had to tick the box to set the IKE and IPSEC proposal as it kept sending the wrong DH group no matter what i had configured on the dlink....
view more
Resurrecting previous unanswered question in a more appropriate forum: I need to force anyconnect client due to security reasons as it denies local LAN Access, enables firewall rules, inserts routing table entries, and forces DNS by default, where op...
view more
I am the Network On the left hand side(FW1 and R1), and FW1 Outside int IP is a nat from R1(so I need to enable NAT-T on FW1 for that).I can reach behind the FW3 as long as it does not nat the IP that I am trying to reach, due to the IP limitations to man...
view more
Dear Members, I am new to ASA Firewall. I want to add remote Networks for an existing tunnel, but i have no idea how to go to the config of the existing tunnel from the command line, as there are multiple tunnels configured.. Kaleem