Nexus 9508 vPC with a Router

[Anuoluwapo Fatokun]

Hi All,

I need your hel. Im new to nexus switch. I configure a router to have a port channel pair to two vPC peers.

running sh vpc on the two vPC peers shows the port channel, vPC  is fine and display the portchannel to the router is fine, but if i run sh etherchannel  summary on the router...its not showing anything.

pls is this the normal behaviour

my nexus switch is Nexus 9508 and router is 2911 

[Steve Fuller]

Hi,

I've never tried port-channels on an ISR and don't have any to test with, but perhaps you're running into the same issue as shown in the Etherchannel is ISR2900.

If you run the show interface port-channel command do you see any output, traffic being sent and received on both links etc.?

Regards