Nexus Devices

Good evening, teamAny suggestion how I can recover console password of a nexus 3000?I have tried the below but it is not working:switch(boot)# config tswitch(boot)# admin-password new-passwordswitch(boot)# exitswitch(boot)# load n3000-uk9-kickstart.6...

 I want to take a daily configuration backup of a nexus 9k switch using a phyton script to an SFTP server. Please assist with the configuration.

Hello, I reserved the NDFC sandbox and connected using the standard VPN connection. I'm unable to access the NDFC GUI with the given IP address. I RDP into the devbox and tried to connect to the Nexus Dashboard and was unsuccessful. I'm able to ping ...

Hi Cisco Family,I'm experiencing an issue where I've just purchased a new Cisco Nexus 3064-X on which the n3000-uk9.5.0.3.U5.1f.bin image is installed. We've to enable features for each configurational protocol such as " Feature BGP or Feature OSPF" ...

Hello Everyone! I'm trying to create/write a file in bootflash: through a script and It fails... I tried to run the command directly in the TCLSH interpreter but I get this message: N7K-CORE# tclsh N7K-CORE-tcl# open bootflash:///clock.log "a+" could...

Hello, I need to enabled jumbo frame on the port-channels on Nexus 7706. These Nexus 7Ks also have OTV which is use to stretch VLANs between Data Centres. On all the port-channels, the MTU is : 1500 as below: interface port-channel101description ### ...

Hi,I have some questions about installing new line cards in Cisco Nexus switches. The switches are working in VPC mode.1. ¿Is it possible to install the line cards while the devices are working? or is it necessary turn off each switch?2.Considering t...

`Hello All,I've recently been introduced to a setup with a Nexus 7004 chassis running as interconnect to the orgs's servers. The Nexus device then connects back to the core. There are multiple SVI's setup on a primary VDC. These have historically bee...

The problem:  We have 2 Data Centers about 40 miles apart each with there own connection to the internet.. and also 2 wires between the N7Ks at each site for data center to data center.  Each data center has 6 switches...  two 7ks, 2 5ks, 2, 2ks.Alth...

When will the NDO Data Model be updated for the separate L3 Out and Tenant Polices Templates? We are running version  4.2.1d and utilising terraform/yaml files to create new transit L3Out and would like to fully automate the process but current NDO M...

Hey Everyone,how can i limit TX/RX or Upload/Download per VLAN? on Nexus 3000?ExampleVlan 10 = 20MbpsVlan 20 = 70Mbpsit is possible or not possible? thank you     

I need to configure PIM multicast across 4 Nexus, I have the RP configured and I see that ip pim spare-mode is configurable on the L2 and SVI interfaces.  However I don't see that option on Port-channels and vPC interfaces. Is that option available?