Console access to the router and Router must be running release 5.3.2 or higher
System must not have 800G (tomahawk) line cards, (see caveat (a) in list below)
Before the upgrade process starts, and prior to removing any RP from the chassis, make sure that “show redundancy” shows NSR and standby card is ready.
Make sure any none 5.3.x software is removed from the system (ie admin install remove *4.3.4*)
Enable console logging on the router and on the terminal application (optional)
a)The system must NOT have Tomahawk(400G or 800G) Line cards in the chassis prior to attempting this as the EOBC link between Tomahawk and newly inserted RP2 will be down which will interfere with the failover from RP1 to RP2. If there are Tomahawk cards in the chassis, they need to be removed or powered down for the upgrade to be successful. ‘admin-config #hw-module power disable location 0/1/cpu0’
3) Upgrade process:
1)Issue show redundancy and make sure NSR and Standby card is ready
Hi All, I have 15 Cisco phones model SPA502G in the company and i'm connecting them to the PBX by IP address and subnet mask. Now i purchased new phone model 8845 but i couldn't registered the phone in the same way as it's required CUCM QR to r...
I have ASR100x devices with ISG (iWAG) using multi vrf, services loading via Radius.Is it possible to use mdns routing features of IOS XE on ASR with that configuration? Or these features are incompatible (mdsn and isg)?
Hi All, I have tried to update the below sysadmin's SMU on ASR9K, but got the below error when "install add", is there any other method to install those sysadmin's SMU? RP/0/RSP0/CPU0:ios(admin)#install add harddisk:asr9k-sysadmin-6.5.3.CSC...
Hi, We have a POP with ASR 1002 for BNG and CGNAT.The problem is with the configuration of cgnat, we can't access the cpe from outside of asr by interface of uplink.We tried to accept by using an access list, but without success. Follow the conf...