Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have this on ASA which allows an AnyConnect user to specific networks only.
username Samsung attributesvpn-filter value ACL-VPN-Filter-Samsungservice-type remote-accessaccess-list ACL-VPN-Filter-Samsung extended permit ip any host 10.1.1.6acce...
Hello, quick question about IS-IS and multi-area (49.0001, 49.0002, 49.0003 etc.) but all nodes are L2. Does this bring any benefits in terms of smaller LSDB, scalability etc.?
Hi, I have a bunch of C220 servers connected to the FI's. The OS has to be reinstalled quite often on all of them but every time I have to reset CIMC server on every node manually, otherwise the installation fails. How can I reset the CIMC server on ...
Hi, with an 8 node HX cluster and LAZ enabled, 4 zones/2 nodes per zone, how many node failures can be tolerated in order to keep the quorum? If the majority of servers must be online than only 3 nodes could fail, right? Or is it different with LAZ e...
Hi,what if the ingress interface is MPLS, and the interesting traffic is L3VPN.I think that the A9K needs first to check the service label of the L3VPN and then it will know the IPv4 address?I assume that ABF can't work with that, or am I wrong?
Hello, the ISM is not supported anymore. Please don't use it anymore.
The replacement for ISM-100 is VSM, which has also reached end of SW support. You can check out more hereEnd-of-Sale and End-of-Life Announcement for the Cisco ASR9000 Virtualized ...
Hi, have you managed to fix that?I am replying to the BNG with the Loopback Interface and this is then the giaddr for the DHCP server.The subscriber gets the correct IP address.There is a problem though. I have one access-interface, but when there ar...
