RV042: Multiple remote networks in site-to-site VPN

[malmgren]

Hi, is it possible to list 2 or more remote networks (subnets)  that I want to let VPN users have access to?   At present, the only choices are "IP Address", "Subnet" or "IP Range".   I have it set right now for subnet - a /24, but we've recently started a migration to a new internal network and I want to be able to have the VPN users have access to it as well.  Is this possible? 

Thanks!

[malmgren]

I'm aware of the answer "create multple VPN tunnels" but I would prefer not to do this every time for every RV042 we have deployed.

[malmgren]

Nobody has an answer?  I guess it's not possible?

[Aleksandra Dargiel]

Hello Malmgren,

It is possible on condition that the subnets can be summarized. For example if you have subnets: 192.168.1.0/24 and 192.168.3.0/24 on one site of VPN tunnel, you will use summarization such as subnet 192.168.0.0/16 for VPN policies. This is working just fine.

Aleksandra Dargiel

SBSC Cisco

[zechner.dario]

A few weeks ago I was asking a similar question. Maybe it helps you...

https://supportforums.cisco.com/thread/2085484