Greetings Everybody.
We've a RV325 that was constantly dropping its LAN IP address requiring turn off/turn on to fix so purchased a replacement RV345.
We knew about the weird Static DHCP limit on the RV325 but hoped that it would go away with the RV345. Fat chance!
This is what was done on the new RV345:
1. Reset to factory.
2. Updated firmware from 1.0.01.16 to 1.0.02.16.
3. Setup the new RV345 with pretty much the same settings as the old RV325.
4. Setup a critical Site-to-Site VPN Tunnel.
5. Entered a few devices into the Static DHCP Table.
6. Tested VPN Tunnel and DHCP - all appeared to be okay.
7. Continued to enter devices into the Static DHCP Table okay until we hit about 25-30 entries.
8. Were unable to add any more devices.
9. Even after deleting 10 devices from the Static DHCP Table, we were unable to add additional entries.
10. Deleted all Static DHCP Table devices but were still unable to add new devices until the RV345 was rebooted.
11. Still can't add more than 25-30 devices.
Does anyone have any idea how to get past the 25-30 device limit in the RV345?
We need to be able to enter at least 75 devices into the the Static DHCP Table.
Thanks in advance for the assist.
