9400 stackwise support for SDA border

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-03-2020 12:26 PM
Hi there,
afaik, currently stackwise virtual is not supported for 9400 deployed in SDA. Where can I get info that when it will be supported?
Thanks in advance,
Please rate and mark as an accepted solution if you have found any of the information provided useful.
- Labels:
-
SD-Access
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-03-2020 01:22 PM
Hello Kanan,
Yes, C9400 are still not supported.. It will be supported in one of the upcoming release..
Regards
Mahesh N
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-05-2020 12:02 AM
Hi, Please check the information related to StackWise support on Cisco Catalyst 9400 for SDA Edge and Border. It is supported with the start of Cisco DNA Center 1.3.3.x. The latest version 1.3.3.6 is updated on July 16, 2020.
- Customers can now use Cisco DNA Center to manage the StackWise Virtual device, along with monitoring the health and status of StackWise Virtual ports and links.
- SVL support has been added on edge and border nodes. Base automation will discover manually configured SVL devices. The user can configure fabric roles such as edge/border or border + edge (B+E).
- Base automation (inventory, discovery, SWIM, topology, template programmer) and assurance support for Cisco Catalyst 9500 and 9400 Series StackWise Virtual switches.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-05-2020 04:06 AM
That' is great info!
So, if you use not as FIAB or B+C then we can do SVL ,right?
In current case we will need additional Control node, if we want to deploy 9400 as SVL in SDA.
Regards,
Please rate and mark as an accepted solution if you have found any of the information provided useful.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-06-2020 11:33 AM
Hello Kanan
C9400 SVL as Border/Control, Edge, FIAB is all part of upcoming release and this is the latest. .. Only C9500 SVL was supported in 1.3.3.x..
Regards
Mahesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-07-2020 01:24 AM
Hi mnagired,
what confused me in above mentioned link:
SVL support has been added on edge and border nodes. Base automation will discover manually configured SVL devices. The user can configure fabric roles such as edge/border or border + edge (B+E).
So, by word, if we do manual SVL and give B or E or B&E role to node, it should work, shouldn't it?
Please rate and mark as an accepted solution if you have found any of the information provided useful.
