Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Can anyone answer with regards to fiber link connectivity between spine and leaf?First Question:Is it mandatory to have all the links between these devices to be at same speed? I mean if I connect a leaf switch to one spine at 40G and to another s...
I want to pair 2 C9500-16X switches using SWV technology. However I don't want to use multiple links for SVL. This will save me two ports. Since almost all interfaces for the downlinks are having dual leg connection, I don't see the issue of keeping ...
Hi Guys,Currently I am using WS-6509-E switches running VSS technology as collapsed core connected with 10 Distribution switches 3850. I have all VLANs configured on this Core switches and is a pure switched network with trunks ports configured betwe...
Hi Guys, Is it possible to use Stackwise Virtual technology at Intermediate Node as it is a point of aggregation for access layer and it can still support layer-3 routing. Regards,
It is possible to connect DHCP/DNS server directly to SDA fabric. It can be a part of underlay or overlay depending on the design. If these servers are part of overlay network then it must be assigned an endpoint IP address within the appropriate VN ...
If the switches use Network Essential
Hope the above comparison will clear any doubts about the impact of having different licenses.
Regards,
Mir Hafeez Ali
Its a document which is provided to the End user after completing the implement to validate and test that the Network Ready For Use (NRFU). All the scenarios and the configuration information is available to test and allow the user to signoff the com...
Thanks for your reply. Its helpful.Is there any limitation for connectivity between spine and leaf. Can we find some resources from Cisco in the design or best practices? For port-channel for sure it is mandatory to have same speed on all the link. B...
Hi,Based on the hardware you mentioned, you can use both 9500 as Control/Border node and the 9407 as Edge Node with two 9300 as Fusion router. However, the design requirement should be based on Number of users, VNs and SGTs you use in the solution. I...
