07-14-2021 10:01 PM
Hi community!
I'm putting together a design for an SDA campus fabric in parallel with my existing campus network, the goal is to mimic the existing network as much as possible. It's a pretty standard 3 tier campus design.
Currently:
So I essentially have the following config on the current switchports:
SW1(config)#interface gig x/y SW1(config-if)#switchport mode access SW1(config-if)#switchport access vlan 100 SW1(config-if)#switchport voice vlan 101 SW1(config-if)#exit
In terms of SDA host onboarding, what the best way to mimic this type of setup?
Given that wired authentication (as of now) is not a requirement, does the Host Onboarding workflow with either the "No Authentication" or "Open Authentication" template allow me to configure both a data and voice VLAN (assuming I've already reserved the data and voice pools) on selected switchports ?
Solved! Go to Solution.
07-16-2021 05:52 AM
Hi,
If you don't use 802.1x/MAB, you can use 'no authentication' for host onboarding general page.
Then, on each switchport you will select User Devices for 'Connected Device Type' and 2 data pools:
- Data (Data VLAN)
- Voice (Voice VLAN)
BR,
Octavian
07-16-2021 05:52 AM
Hi,
If you don't use 802.1x/MAB, you can use 'no authentication' for host onboarding general page.
Then, on each switchport you will select User Devices for 'Connected Device Type' and 2 data pools:
- Data (Data VLAN)
- Voice (Voice VLAN)
BR,
Octavian
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide