Intermediate Node Roles

[fatalXerror]

Hi, I would like to check if I can put an intermediate node as a Control Plan node and being part of the underlay? thank you

[Andrii Oliinyk]

If your Fabric Site will stay within configurable CP limits after adding new CP u just go to Provision / Fabric Sites / Site select intermediate switch & assign it CP role. 

[fatalXerror]

Hi @Andrii Oliinyk , basically, the original plan for the intermediate node is just to distribute my EN for the underlay but since because of budget, I am planning to set the intermediate node as CP as well as underlay but not sure if it is feasible.

[Andrii Oliinyk]

i'd say fully feasible. u also can colocate CPs with BNs.
Cisco Software-Defined Access Compatibility Matrix