Software-Defined Access (SD-Access)

Hi Community , on 9300/9500 Switches with Network Adavantage License is AVB supported. We are looking to use this feature in SDA-Fabric with ISIS Routed Underlay (LAN-Automation). Audio Video Bridging Configuration Guide, are no Infos about SDA. http...

LC/0/0/CPU0:Dec 1 20:05:33.014 BKK: dumper[56]: %OS-DUMPER-7-DUMP_REQUEST : Dump request for process pkg/bin/nfsvr LC/0/0/CPU0:Dec 1 20:05:33.018 BKK: dumper[56]: %OS-DUMPER-7-DUMP_ATTRIBUTE : Dump request with attribute 7 for process pkg/bin/nfsvr L...

Hello guys,I am trying to connect to my Catalyst6880X-LE via SSH.The configuration looks like this:ip ssh pubkey-chainusername adminkey-stringssh-rsa AAAAB3NzaC1yc2EAAAADAQABAAACAQC82TSQRtkH+hJpGoOHmPGingp7S5a0KOxLz/0j52U474tPVpoF5bdtWZTYYvgn7oQ/ovOc...

HiWhats the guidelines on using the cli to make changes to a Switch when the Switch is part of SDA is it ok to do?  Will DNAC see the changes once I (write mem) after my changes.???and also if we loose access to DNAC it would be the only option would...

Hi All, Do we need the ISE and the DNA center to be implemented on the same site? or we just need to grant connectivity between them? is there any other requirements for this integration? Many Thanks,  

Hi, With reference to slide 49 in BRKSEC2845 (see attached file) If i use Cisco FTD as fusion firewall, and i want to use Src and Dst SGT in the fusion firewall for firewall access control rule. Do i still need to configure inline SGT at the border ?...

Hi, Multiple places in the SDA configuration it is possible to define traffic types to be Data and/or Voice.Choose the Traffic type from the drop-down list. You can choose to send voice or data traffic through the virtual network.You have the option...

We have a SDA environment where we created a L2 Vlan with a Gateway (GW) outside Fabric. For the GW we created a L2 Handoff on the border, for the network we created a L2 Network with the option "Layer-2 only". Now we are facing some issues with ARP ...

Hi All,   For Cat 9K switches used as Border and control nodes in an SDA setup. do we need to have a specific physical interface on the switch for control plane or we can provision all physical ports(interfaces) as a control plane port.   Many Thanks...