No Devices Found When Deploying VNs to Fabric Devices in Cisco DNAC

[techno.it]

Trying to deploy VNs to the fabric devices, but when I reach the preview configuration step, it shows "no devices found." The VN has already been created and assigned under the fabric site.

Some quick checkup

1. Fabric devices (Border Nodes, Control Plane Nodes, and Edge Nodes) are correctly assigned their roles
2. Confirmed that the devices to which I want to deploy the VNs are part of the same Fabric Site.
3. Devices are in managed state and reachable

Attaching screenshot.

I would appreciate any help.

[andy!doesnt!like!uucp · Accepted solution]

probably u dont have anything to deploy except of VRF definitions. i noticed behaviour like this. Save intent & then do L3-handof for VRF. It will push both intents.

[techno.it]

Thank you @andy!doesnt!like!uucp Issue resolved.

Created VNs. Intent saved

Created Anycast Gateways and deployed all config on the devices.