06-09-2023 06:27 AM
Hi there
i'm trying to figure out configuration use-case for the Subject. I've read Cisco SD-Access Multicast - Cisco Community but it seems to use RP on the BN instead of expected RP on the FHR.
1. Would we still have (*,G) entry on the FE like this?
(*, 227.7.7.7), 1d01h/stopped, RP 9.253.253.2, flags: SJC <-- address of external RP on FHR
Incoming interface: LISP0.4099, RPF nbr 9.254.254.66, LISP: [9.254.254.66, 232.0.3.170]
...
2. on the br-2?
br-2#sh ip mroute vrf corp 227.7.7.7 verbose
(*, 227.7.7.7), 00:41:40/00:03:20, RP 9.253.253.2, flags: Sp
Incoming interface: Vlan3049, RPF nbr 9.253.253.2
3. We wouldnt have any RP configured within Fabric, right?
Solved! Go to Solution.
06-14-2023 03:55 PM
Hi Andy, my lab is offline at the moment so giving a theoretical answer without validating. #3 is definitely correct, there is no RP within the SD-Access Fabric when you nominate RP outside the fabric from the Multicast Configuration Workflow. #1 and #2, this looks correct to me and makes sense to me. Ideally I'd prefer to validate on the CLI of a real switch but cannot right now. Lab should be back online next week if you need CLI validation. Cheers, Jerome
06-13-2023 11:58 PM
Are these outputs from your lab or from the document? I cannot find the first output.
*,G can be created by either an IGMP membership report (LHR) or along the S,G in the FHR
2. BR2 in this case seems to know the RP upstream vlan 3049, where RPF resolves, this is an output of RP outside of the fabric
06-14-2023 12:31 AM
the output i gave is modified output from referred document assuming that RP is on the FHR instead of BN. Basically now i'm pretty sure that answers would be 'yes' for all 3 questions.
06-14-2023 03:55 PM
Hi Andy, my lab is offline at the moment so giving a theoretical answer without validating. #3 is definitely correct, there is no RP within the SD-Access Fabric when you nominate RP outside the fabric from the Multicast Configuration Workflow. #1 and #2, this looks correct to me and makes sense to me. Ideally I'd prefer to validate on the CLI of a real switch but cannot right now. Lab should be back online next week if you need CLI validation. Cheers, Jerome
06-14-2023 09:56 PM
thanks Jerom
no need to Lab as we on the same page
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide