SD-ACCESS over VSAT links
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-08-2020 07:45 PM
Hi all,
I found out that there is a limit of 200ms of RTT from DNAC to Edge. So, in the case of a branch where that I have a satellite hop, like a VSAT, it is not possible to configure SD-ACCESS for the LAN? I was thinking of using SD-WAN as transit, but the delay is stopper. Any way to solve it or should I go with traditional LAN approach?
Thanks!
- Labels:
-
SD-Access
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-10-2020 10:31 AM
Hi,
Correction, it's actually 100msec RTT between DNAC and Fabric nodes and it recommended to be with those limits for smoother device administration.. Latency beyond 200ms RTT is not recommended at all.. This is agnostic of Transit type..
Hope this helps..
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-10-2020 12:10 PM
Hi,
Thanks a lot for the answer. So there is no way to use SD-ACCESS through VSAT links? Any plans to support more delay in the connections?
Thanks,
Nacho.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-23-2020 10:18 AM
Hi Nacho,
No Committed plans as of now.. So would recommend to be within those limits..
Regards
Mahesh
