Hello,
I have a situation where there is SDA-A design with dual C9500 as control/border , C9300 as edges and virtual catalyst center/ISE, all in the same building.
We need to add new building to this fabric, the new building has C9500 as distribution, c9300 as edge switches, the plan was to connect the new C9500 as underlay to the Main C9500(control/border) with fiber connection.
However, there is no fiber between the 2 buildings and we will have to connect over wireless bridge using outdoor P2P APs.
My question is if this setup will be supported, by replacing the fiber connection with the wireless bridge between the 2 C9500, is there any concern here, what about the gumbo frames? , delay..etc,
And in general, can I have this setup and to have the 2 buildings in the same fabric using the same catalyst center?
Thanks & BR
Moamen
