Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello
I need to know and make sure of the following cards can be used in C9400 as edge node in SD-Access design
(C9400-LC-48HN, C9400-LC-48U, C9400-LC-48P)
As we can't see them in the current compatibility matrix, however we installed some of them y...
Hello,
I have a situation where there is SDA-A design with dual C9500 as control/border , C9300 as edges and virtual catalyst center/ISE, all in the same building.
We need to add new building to this fabric, the new building has C9500 as distribution...
Hello,
I need to know how exactly the Ceiling Mic pro can connect to the Board Pro55/75 G2, as I understand Ceiling Mic pro should connect through Ethernet cable to a POE port on the codec, however, the Board Pro55/75 G2 does not have this port (li...
Hello,
I have a customer who want to upgrade from 12.5 to 15, he has BE7000-M5 servers, I need to know if I can use the same HW to install BE7000 Ver 15.
Thanks & BR
Moamen
Hello,
I have a situation where we need to connect Extended node to fabric edge , and I have the follwoing questions:
1- Can we connect the extended node switch c3560-CX to fabric edge C3650 ? (as far as I know it should be supported, but I need d...
Hello,
Thanks for your reply, actually I'm interested in this exact session as it should include some info about how to cascade multiple Fabric edge nodes behind each other, but I can't find this info in the session you shared.
But thanks anyway , st...
Hello Scott,
I'm interested to find the cisco live session you mentioned above, can you share with me if you have it, as the link you shared is now broken, and the session not available now on Cisco live.
https://www.ciscolive.com/c/dam/r/ciscolive...
