12-15-2019 08:29 AM
Hi All,
I have a hierarchy that consists of a large campus with the setup as below. This will be a single fabric site at the London level. This all works ok, however I have hit an issue when configuring wireless. I have discovered the WLC and assigned it to building 1 as this is where it is located. All APs have successfully registered to the WLC and I have assigned them to the required floor. I can assign provision the APs in building 1 without any issues, however when provisioning the APs in buildings 2 and 3, they fail with the error 'APs cannot be assigned to Site's Floor 1' There are no Wireless Controllers in these Sites'
Global -> UK -> London -> Building1 -> Floor1
Global -> UK -> London -> Building2 -> Floor1
Global -> UK -> London -> Building3 -> Floor1
Whereabouts am I supposed to locate my WLC in this scenario? I thought that the above should work as the WLC is in the same site just a different building. I also tried to assign to the area level of London but DNAC produces an alert stating that I can only assign to a building or floor. Is this right as that would mean I need a WLC for every building?
Solved! Go to Solution.
12-15-2019 08:40 AM
I figured this out. When provisioning the WLC, I didnt select the AP locations that it should manage. By default it sets itself to manage Building1 and associated floors. I set this to the London level and now I can provision my APs correctly.
12-15-2019 08:40 AM
I figured this out. When provisioning the WLC, I didnt select the AP locations that it should manage. By default it sets itself to manage Building1 and associated floors. I set this to the London level and now I can provision my APs correctly.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide