Wonder if anyone would offer some suggestion on this:
I want to use VLAN 100 (brand new VLAN and brand new subnet) as my replication network between two HX Clusters in two different locations (inter-connected via Dark Fibre). However I want to use a new uplink/port-channel, instead of the existing one, just for the replication traffic from FI.
I am planning to use VLAN groups within UCSM to "isolate" VLANs to specific uplinks/port-channels, however:
1. Should I just create one VLAN group to include the new VLAN100 with the new uplink/port-channel? Or should I do two VLAN groups: one for the VLAN100 and one for the rest of my production VLANs?
2. Should I also create a new pair of vNIC templates dedicated for the VLAN100 and use them as the uplinks for the new virtual switch in vCenter?
Good afternoon Friends, these days I was accessing the DNAC manager and my surprise is that I did not have access, after a basic analysis I observed that the equipment was operational, but without being able to access it via DNA GUI (browser) I also ident...
Today we are going to talk about how to configure backups in the Cisco ACI APIC Dashboard. As you might know APIC is a UCS based CIMC controller and we can check the configuration backups on the Cisco ACI APIC Dashboard. Remember that the HA solution must...
Listen: https://smarturl.it/CCRS9E14 Follow us: https://twitter.com/CiscoChampion
Organizations are undergoing digital transformation like never before. Global spending on digital transformation of business practices, products, and organization...
Recommended for customers on ACI releases 4.2(7r) and above or 5.2(3g) and above. Are you tired of manually gathering ACI logs and tech-support data?To this day, the process of gathering ACI logs and uploading them to your TAC case was cumbersome - y...