Hello, I installed this package new a few weeks ago and just now got back to it. I forgot the admin password for the gui after I launch fabric manager. Is there any way to reset it? I have not found anything so far. Thank you,Benita
Forum Posts
HelloI need to know if cisco SFP compatible DS-SFP-FC16G-SW with IBM server MT:8721-HC1
I am running DCNM 11.4 and have configured the Administration --> Performance Setup --> Threshholds as well as Administration --> Performance Setup --> SAN Collections and I get no host port performance when I look in Monitor -->FC Ports --> Perform...
I'm trying to find some documentation for the MDS9148S Switch that proves the support of the following port types: F_Port (Fabric), M_Port (Mirror Port) and E_Port (Switch-to-Switch). I easily found F_Port and E_Port:Fiber Channel standard port types...
I am trying to find out where zoning changes are logged to. For example, an admin creates a new zone, adds it to the active zoneset and commits the changes (we usually do this via CLI). A little while later we get a report of an issue and would lik...
Resolved! DCNM ova import stuck at 50%
Hi I download the DCNM VMware OVA, and during the import of the OVA in VMware ESXi, 6.7.0, 14320388,The task is stuck at 50% for hours without any progress.Any idea ?
Hi ,Currently in my both DC's , we are lacking capacity on Cisco MDS 9148 production Switches but we got new Brocade switches to extend the capacity of SAN switches - which means we want to connect more physical servers to brocade switches or extend ...
Hello guys , I have question about support of new ciphers for SSH in soft. How I can check that in soft m9100-s3ek9-kickstart-mz.6.2.29.bin for mentioned MDS are new ciphers for SSH or i can modify SSH attributes for client like ciphers MACs etc for...
Hello Community, I tried to describe my issue through the title of this discussion. I have a problem in regards to the connection between the MDS Switches and Nexus Switches at a Customers Data Center. So far we have configured our Ports in this way:...
In HyperFlex native replication, how many target datastores can you pair with a single source datastore?
I have a pair of MDS 9132T on 8.4(2a), I have previously successfully configured fresh fc ports, when going to use a port that was pre-populated with an SFP (just to imply some previous config may have existed) I assigned the vsan, however I noticed ...
Dear , I have the below architecture. as you can see FI_A connected to MDS_A and FI_B connected to MDS_B. both MDS are connected to three storage array (netapp ,hp3par, IBM).My questions :I have only one vSAN (vSAN100) on both MDS (A&B) , the same al...
We have a recently installed MDS 9148T. This switch is running an HTTPS service with a self-signed certificate. I've created a trustpoint and generated a CSR and obtained and installed a certificate. I disabled/enabled the http-server but it still pr...
Hello, Sorry for this long-winded post... I am more of a routing and switching kind of guy but stuck managing a small SAN with backend fiber. This is probably a simple task for an expert but its so far out of my area of expertise so I wanted to get s...
I am going to install new QLE2692 Dual-port 16G FC on our UCSC-C220-M5SX servers. My question is "which PCIe slots is best to install them on one or two and I cannot find any post installation steps to ensure I did the install correctly and updated.
