cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

491
Views
0
Helpful
2
Replies
santkumd528
Beginner

ISL merge validation

I am merging the new 9710 with old 9513 and all the 8 ports selected for ISL are in offline state.

How can I validate the ports attempted to  merge? How to verify the logs relevant to  the merge?

1 ACCEPTED SOLUTION

Accepted Solutions
Walter Dey
Advocate

http://www.cisco.com/en/US/products/ps5989/prod_troubleshooting_guide_ch...

The following commands may be useful in troubleshooting PortChannel and trunking:

•show port-channel compatibility-parameters

•show port-channel summary

•show port-channel database

•show port-channel consistency detail

•show port-channel usage

•show interface

•show interface trunk

•show trunk protocol

View solution in original post

2 REPLIES 2
Walter Dey
Advocate

http://www.cisco.com/en/US/products/ps5989/prod_troubleshooting_guide_ch...

The following commands may be useful in troubleshooting PortChannel and trunking:

•show port-channel compatibility-parameters

•show port-channel summary

•show port-channel database

•show port-channel consistency detail

•show port-channel usage

•show interface

•show interface trunk

•show trunk protocol

View solution in original post

other related commands I considered are below. I need to compare them before and after the merge.

show zone status

show fcdomian domain-list vsan x

show int brief | i trunk

show zoneset active vsan x

show zoneset vsan x

In addition zoneset distribution was done from old switch to new switch to pull the Full zoning database to the new switch.  By default the distribution was limited to active zoning database upon the completion of the merge

zoneset distribute vsan x

Content for Community-Ad
This widget could not be displayed.