Hi peeps
Have a little issue with a Cisco NAS NSS 326 Smart Storage 6 bay - with RAID 5 over 6 disks.
Apparently there were some funny business with the performance with the device so someone reset the device from the button on the back.
I've been ask to get everything working but I've bumped into a little problem.
The DHCP address the device pick up is 10.2.7.127, so I open up a web interface and hop on that address and configure password, time etc.
When it comes up to step 6 I've tried selecting "Do not set disk configuration" and RAID 5, then on the finish window to start installing it advises it'll format all disk to continue!!!
We have a lot of data (9GB or so)
Is it possible to continue in any way without clearing the data we have on it? or map it somehow to recover the data?
