
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-30-2011 12:18 PM
My NAS200 will not allow me to add a second drive to the unit.
I had two drives in the NAS200 then we had a power outage. Then NAS000 is on a ups but the power was out for 24 hours
After the power came back on the drive in bay one failed put drive two was ok
I was able to recover the data because I had Raid setup on the drives.
But I got a replacement drive and it never comes active
I took the good drive in bay two and placed it in bay 1 and it works
I put it in Bay 2 and it still works
I just can not get another drive to work in this unit
Any ideas or suggestions
Tom
Solved! Go to Solution.
- Labels:
-
Storage Networking
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-30-2011 07:31 PM
is the second (replaced) drive from the same vendor (make, model and speed-rpm)? if yes, then it could be the conflicting firmware version, either it is older or newer. I have experience the similar issue, I end up upgrading everything to same version, including the BIOS. OR the new drive is bad already.
Regards,
Nisar
Sent from Cisco Technical Support iPad App
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-30-2011 07:31 PM
is the second (replaced) drive from the same vendor (make, model and speed-rpm)? if yes, then it could be the conflicting firmware version, either it is older or newer. I have experience the similar issue, I end up upgrading everything to same version, including the BIOS. OR the new drive is bad already.
Regards,
Nisar
Sent from Cisco Technical Support iPad App
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-21-2019 06:58 AM
bom dia perdi o cd de intalaçao agora nao consigo abaixar algeum poderia me ajudar
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-22-2019 09:17 AM - edited 09-22-2019 09:18 AM
You might want to post over on the linksys site, https://www.linksys.com/us/support-product?pid=01t80000003K7VUAA0
https://community.linksys.com/t5/Network-Storage/Nas200-missing-cd/m-p/254993#M6054
Kirk...
