no storage with a 5428-2, iscsi Windows and IBM ESS

[larry.garibay]

I'm using the Ciso iScsi drivers with a 5428-2 connected to an IBM ESS through Brocade FC switches. I don't the see the storage when I scan for Disk's.

Here's what the ISCSI driver status displays:

Driver Version 3.1.2 for Win 2000 May 27 2003 12:17:35

Target IP: 10.1.7.201 Conn State: ACTIVE Hd: off Dd: off R2T: Off Discovery

Target IP: 10.1.7.201 Conn State: HELD Hd: off Dd: off R2T: off t:0 eui.5005076300c79b75

I've added the log from dbgview and here's the show devices.

[sm542801]# show devices

Fabric Attached Devices detected

Interface WWPN PortId Device Type Lun Lunid Type Lunid

--------- ---------------- -------- --------------- ----- ----------------- -----

5005076300c79b75 0x620d00 Disk 0 MD5 3cbecc472dfdb7b69362988cb843011f

Lun Description Table

Interface WWPN Lun Capacity Vendor Product Serial

--------- ---------------- ----- -------- ------------ ------------ ------

5005076300c79b75 0 65GB IBM 2105800 00024029

*[sm542801]#

Any help would be appreciated. Thanks.

[tblancha]

You say you don't see storage but there is a 65G partition being seen here from the ESS. Is this not the storage you need to connect to? In any case, the 5428 needs to have the storage reply to a scsi inquiry and report LUNs. Until that is successful, you won't be able to attach to any storage over the iscsi. Do a show fcswitch global-nameserver all, to verify the intended target can be seen from the 5428.

Then please post the config for the scsirouter instance and ACL.