Storage Networking

Hello Is there any way to find the list of all switches that are present in the fabric by looking at the MIBs of Cisco 9216 switch ?regardsN.Sankar

Looking at the documenation for Interop between MDS and other vedors.The doc says that IVR is supported in all Interop modes. I am confussed as i read somewhere that IVR is not supported for a vsan in interop mode 2 or3. I may be wrong, any advice wo...

Hi, Is it possible to bind Mulitiple FSIP profiles to 1 physical interface on the MDS switch?? I have multiple FSIP profiles that i need to create, not sure of i should bind them to the same physical interface or different intefaces.Thanks

hiare they any list of products fully tested with MDS9000 familly ?i' m looking for some olders FC products runningonly at 1G thanks in advance for any pointersJYP

Folks, Reading through documentation, i can not find out the differnece between ISL and EISL trunk, which is capable to carrying which traffic. Can they both carry Vsan and zoneset traffic? any information would be highly appreciated.Thanks,

It turns out that we are not using MDS. What can I do as a network engineer to optimize the SAN traffic across WAN (T3)? I am thinking about changing MTU to 2300 for the entire path, setting up LLQ or CAR. Any other features on the router (6500) an...

I'm using MDS 2916 and Cisco ACS 3.1.I'm able to create user accounts in ACS who can successfully log on to MDS 2916 via telnet. However, thes user have "Network-operator" privileges. How can I give this TACACS+ user accounts "Network-admin" privil...

Hi,I was using MDS9500 and Microsoft iSCSI Initiator software to do some iSCSI related test. One test scenario is to create multiple connections in one iSCSI session.The first step is to run the command 'iscsicli logintarget' to create a session on a...

My customer plan to implement iSCSI on SN5428 replaing existing Brocade switch connected to EVA 3000. Does it work. EVA 3000/5000 is not on compatibility list of SN5428. Have somebody done it?