Using Stackwise-Virtual for the first time here. I have two C9500-40X switches that have this incompatibility (even thought I bought them at the same time!):
*Apr 13 20:53:48.850: %IOSXE-3-PLATFORM: Switch 1 R0/0: Apr 13 20:53:48 issu_stack.sh: %BOOT-3-BOOTTIME_INCOMPATIBLE_SW_DETECTED: Incompatible software detected. Details: Chassis 2 is detected INCOMPATIBLE with software version of Active: FAILED: Version '16.06.02' mismatch with Active's running version '16.06.01' for package: 'guestshell'
So, I enabled auto upgrade on switch 1 - then when I bring switch 2 up, I see the above message, then:
*Apr 13 20:53:49.164: %IOSXE-5-PLATFORM: Switch 1 R0/0: Apr 13 20:53:49 auto_upgrade_client.sh: %AUTO_UPGRADE-5-AUTO_UPGRADE_INITIATED: Auto upgrade initiated for switch 2.
*Apr 13 20:53:49.182: %IOSXE-5-PLATFORM: Switch 1 R0/0: Apr 13 20:53:49 auto_upgrade_client.sh: %AUTO_UPGRADE-5-AUTO_UPGRADE_SEARCH: Searching stack for software to upgrade switch 2.
*Apr 13 20:53:49.193: %IOSXE-5-PLATFORM: Switch 1 R0/0: Apr 13 20:53:49 auto_upgrade_client.sh: %AUTO_UPGRADE-5-AUTO_UPGRADE_FOUND: Found donor switch 1 to auto upgrade switch 2.
*Apr 13 20:53:49.203: %IOSXE-5-PLATFORM: Switch 1 R0/0: Apr 13 20:53:49 auto_upgrade_client.sh: %AUTO_UPGRADE-5-AUTO_UPGRADE_START: Upgrading switch 2 with software from switch 1.
OK, that's nice, but then about 15 seconds later, I see this:
*Apr 13 20:54:04.158: %NIF_MGR-6-PORT_CONNECTION_STATUS_CHANGE: Switch 1 R0/0: nif_mgr: PORT lpn:1 changed state from Ready to Timeout.
*Apr 13 20:54:04.159: %HMANRP-5-CHASSIS_DOWN_EVENT: Chassis 2 gone DOWN!
*Apr 13 20:54:04.158: %NIF_MGR-6-PORT_CONN_TIMEOUT: Switch 1 R0/0: nif_mgr: Port 0, LPN 1 on front side stack link 0 connection has TIMEOUT: CONN_ERR_CONN_TIMEOUT_ERR
*Apr 13 20:54:04.158: %NIF_MGR-6-STACK_LINK_DOWN: Switch 1 R0/0: nif_mgr: Front side stack link 0 is DOWN.
*Apr 13 20:54:04.158: %STACKMGR-1-STACK_LINK_CHANGE: Switch 1 R0/0: stack_mgr: Stack port 1 on Switch 1 is down
*Apr 13 20:54:10.171: %IOSXE-3-PLATFORM: Switch 1 R0/0: Apr 13 20:54:10 auto_upgrade_client.sh: %AUTO_UPGRADE-3-AUTO_UPGRADE_FAILED_COPY: Failed to copy upgrade packages from switch 1 to switch 2.
So - the auto upgrade fails, and "Show switch" tells me switch 2 has been removed. So, what do I do now? Do I have to do some sort of manual upgrade of the software on both switches to get them in sync?
