cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
772
Views
0
Helpful
2
Replies

Cisco 2960 Multiple VLAN Configuration

pottsjv66
Level 1
Level 1

Using Cisco 2960 series switches (Have 8 .  2 stacks of 4) to replace 6 old switches.  4 old switches had IP ranges of 192.168.6.*** and all new switches have 10.1.*.* addresses. Core switch has 10.1. as well as 192.168 ip  addresses but i need to configure one vlan (5?) to route to 192.168 address. PC's on 10. address taking a long time to access 192 range. Any help greatly appreciated.

2 Replies 2

as long as you have a layer 2 trunk between the layer 2 and layer 3 switch i dont see a problem

as long as you have the svi's setup correctly

what are you using for vtp?

what are you using for routing?

this information might help us help you more..

Hello James,
D o you have the old stacks still connected?

Can you post your config of the new /old stacks

Res
Paul

Sent from Cisco Technical Support iPad App


Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul