Cisco 4507 RE switch:- standby supervisor is in rommon mode.

[rehan alam]

pls suggest how to recover the standby supervisorn from rommon mode

[Iker Santamaria Molla]

Hello,
First of all, you must check boot configuration and where you put the IOS image.

Copy the same IOS image than it's on active supervisor, in the standby supervisor, poweroff chasis and extract active supervisor.

Now, following this procedure:

http://www.cisco.com/en/US/products/hw/switches/ps663/products_configuration_example09186a0080094ecf.shtml

Best regards.

Sent from Cisco Technical Support iPad App.