04-20-2012 09:41 AM - edited 03-07-2019 06:15 AM
Hello Guys ,
I was wondering if there is possibility to condifure Etherchannel with Trunk port between switch and router , I know this can be done between switch-switch , but what about switch-router
regards,
Solved! Go to Solution.
04-20-2012 10:59 AM
Hi,
Depend on the router. Not every router support it, but some do,
Have a look at this link for an example:
http://www.cisco.com/en/US/tech/tk389/tk213/technologies_configuration_example09186a0080094958.shtml
HTH
04-20-2012 10:47 AM
Hi,
What type/model router?
04-20-2012 10:51 AM
Hi ,
Actually I just wanted to know if that possible or not regardless type of router , since I've asked my teacher and said I'm not sure that possible because we need to configure IP address for each subinterface on the router !
thanks
04-20-2012 10:59 AM
Hi,
Depend on the router. Not every router support it, but some do,
Have a look at this link for an example:
http://www.cisco.com/en/US/tech/tk389/tk213/technologies_configuration_example09186a0080094958.shtml
HTH
04-21-2012 01:31 AM
thanks deeply now I know it can be
regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide