NAT problems on 1811W

[Luke.Ercoline]

Hello all, not sure if this is where I should post this but here goes. I have an 1811W and would like to set each Fast Ethernet port to have its own NAT defined.

Here's my reasoning. I am trying to setup a roll-over for my Internet connection. If the main line (cable) goes down, it will pick up the second line (DSL) automatically. I have the routing tables setup to do this, but the NAT does not work. It will only use the one that was designated for the main Fast Ethernet.

I do not want to go with something like OER (optimized edge routing), because that just seems more confusing and I do not know where to begin with that. Any help would be appreciated. thanks

Luke

[vladrac-ccna]

hello Luke,

just to understand your scenario.

You said that you have "ip nat outside" in 2 interfaces and this is not working?

could you give us more details about your actual configuration.

vlad

[Luke.Ercoline]

Sure thing vlad. I will get the actual config when I go back to the office tomorrow.