I am setting up a vm environment for a customer in my lab off site. I have two stacked 3750-x switches, a san, and threes UCS c220 M3S servers for hosts. I am trying to separate the lan traffic, san iscsi traffic, and san management traffic using vlans.
The problem is i'm unable to communicate cross vlan with my current config, which I have attached to this post. The only noteworthy things in my conifg is that the ip route 0.0.0.0 0.0.0.0 192.168.83.6 is referring to a switch stack they have on site, that I will connect this stack to using the first two trunk ports on each switch, that I do not have here in the lab. I don't want to cause any confusion in why I have things set a certain way.
I have the devices on each vlan using the ip for the respective vlan as their default gateway. With my current config I am unable to reach the management interface of my SAN on vlan100 with my laptop on vlan1.
Can anyone take a peek at my config and see if they spot what i'm missing to communicate cross vlan?
