I am trying to resequence an ACL used for PBR ona Route-map.. it is not working see extract below, is it something to do with being used on a route-map?
IP access list Guest-VMO
statistics per-entry
10 permit ip 10.17.252.0/22 any
13 permit ip 10.27.254.0/23 any
16 permit ip 10.27.253.0/24 any
20 permit ip 10.27.252.128/25 any
23 permit ip 10.27.252.64/26 any
25 permit ip 10.27.252.32/27 any
27 permit ip 10.27.252.16/28 any
XXX-sw01# conf t
Enter configuration commands, one per line. End with CNTL/Z.
XXX-sw01(config)# resequence ip access-l Guest-VMO 10 10
XXX-sw01(config)#
XXX-sw01# sh access-l Guest-VMO
IP access list Guest-VMO
statistics per-entry
10 permit ip 10.17.252.0/22 any
13 permit ip 10.27.254.0/23 any
16 permit ip 10.27.253.0/24 any
20 permit ip 10.27.252.128/25 any
23 permit ip 10.27.252.64/26 any
25 permit ip 10.27.252.32/27 any
27 permit ip 10.27.252.16/28 any
