routing solution

[zeuscyril]

hi all,

i am attaching one network diagram , in that i need traffic flow on both side

the place which i put ??? mark wat device i can use , i can use normal home router.

or anyother possible solution for this kind of network.

[lgijssel]

If the number of ports on your existing 887 is not sufficient, you can place an 881 there:

http://www.cisco.com/en/US/prod/collateral/routers/ps380/data_sheet_c78_459542_ps380_Products_Data_Sheet.html

You may also use a switch to connect multiple devices to the same interface of the router.

regards,

Leo

[zeuscyril]

hi leo,

it doesnt matter the ports , what i need is to able to communicate both the subnets from otherside .

but the vpn is terminating on 10.60.1.0 not on the 192.168.1.0

i am using one ip from 10.60.1.0 network as outside interface of 192.168.1.0 network

i am able to ping from 192.168.1.0  to 193.169.1.0 but revrese is not happening.

thanks

cyril

[cadet alain]

Hi,

i am able to ping from 192.168.1.0  to 193.169.1.0 but revrese is not happening

On internet or the tunnel?  have you enabled icmp inspection on the ASA?

Regards.

Alain.

[Marius Gunnerud]

Is 192.168.1.0 a new addition to the network? if so have you adjusted the ACL that the IPSec uses to identify traffic to be sent over the VPN?