01-14-2014 10:09 AM - edited 03-07-2019 05:33 PM
I have some SG200 switches. Some are small -08 versions running 1.0.3.3 firmware.
I have the
Cisco Small Business 200 Series Smart Switch
Administration Guide Release 1.3
The manual alludes to places that I can't find to set up SNMP.
It appears that Security has to be set up first - but I can't find the places mentioned.
Does this switch have SNMP at all???
If so, how do I get to it to configure it.
I'm sure I can configure it just fine but I need to find WHERE?
Thanks
01-14-2014 12:07 PM
From what I read in the Release Notes, SNMP support was added in Version 1.3 to the 200 series switches, which is unfortunately not supported for the SG200-08.
Don't blame the messenger ;-)
Regards,
Rolf
01-14-2014 12:11 PM
Ah! OK thanks Rolf!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide