cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
613
Views
0
Helpful
1
Replies

slm and CISCO catalyst

ciscocips
Level 1
Level 1

Hello gurus.

I need to create a 802.1q trunk between a CISCO Catalyst and a CISCO SLM224G switch.

No problem for the IOS switch, but I don't have clear how should I create a trunk with the web interface of the SLM224. The docs are not explaining anything on this.

Anyone of you can help? Thanks so much....

Cips

1 Reply 1

Reza Sharifi
Hall of Fame
Hall of Fame

Hi Cips,

According to the admin guide it is under vlan management>port setting> then click on acceptable frame type then you see tagged or untagged.

Here is the admin guide:

http://www.cisco.com/en/US/docs/switches/lan/csbss/slm2024/administration/guide/SLM_Admin_Guide_Publish.pdf

Good luck

Reza

Review Cisco Networking for a $25 gift card