cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
291
Views
0
Helpful
1
Replies

Unable to configure HSRP Virtual ip on IE4010 Switches

Hello,

We have got the New IE40101 Switches and I am unable to configure HSRP Virtual IP on IE4010 Switches.

DS-SW1(config-if)#standby ?
<0-255>          group number
authentication   Authentication
bfd                   Enable HSRP BFD
delay                HSRP initialisation delay
follow               Name of HSRP group to follow

DS-SW1#sh ver
Cisco IOS Software, IE4010 Software (IE4010-UNIVERSALK9-M), Version 15.2(8)E1, RELEASE SOFTWARE (fc8)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2021 by Cisco Systems, Inc.
Compiled Tue 12-Oct-21 05:13 by mcpre

ROM: Bootstrap program is IE4010 boot loader
BOOTLDR: IE4010 Boot Loader (IE4010-HBOOT-M) Version 15.2(4r)EC, RELEASE SOFTWARE (fc1)

DS-SW1 uptime is 1 hour, 42 minutes
System returned to ROM by power-on
System restarted at 01:26:55 UTC Wed Mar 30 2011
System image file is "sdflash:/ie4010-universalk9-mz.152-8.E1.bin"
Last reload reason: Reload command

 

This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.

A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html

If you require further assistance please contact us by sending email to
export@cisco.com.

License Level: lanbase
License Type: Permanent Right-To-Use
Next reload license Level: lanbase

cisco IE-4010-16S12P (APM86XXX) processor (revision V0) with 1048576K bytes of memory.
Processor board ID 
Last reset from power-on
3 Virtual Ethernet interfaces
28 Gigabit Ethernet interfaces
The password-recovery mechanism is enabled.


mac-refresh     Refresh MAC cache on switch by periodically sending packet from virtual mac address
name               Redundancy name string
preempt          Overthrow lower priority Active routers
priority             Priority level
redirect           Configure sending of ICMP Redirect messages with an HSRP virtual IP address as the gateway IP address
timers             Hello and hold timers
track               Priority tracking
use-bia          HSRP uses interface's burned in address
version           HSRP version

1 Reply 1

marce1000
VIP
VIP

 

 - Can't see from that output why you can not get HSRP going , check : https://www.cisco.com/c/en/us/td/docs/switches/lan/cisco_ie4010/software/release/15-2_4_EC/configuration/guide/scg-ie4010_5000/swhsrp.html , for guidelines.

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
Review Cisco Networking for a $25 gift card