Hey
As of now, i'm having two ISR 4200 and two ISR 4300 series routers with 'IOS XE SD-WAN' upgrade. Even though, i'm unable to view or execute sd-wan commands such as below. I'm not sure where i'm going wrong. Is there i need to activate any license or anything. Please suggest.
show sdwan
show sdwan policy
show control connections
show vpn
ISR-4221-V2#show sdwan?
% Unrecognized command
ISR-4221-V2#show license
Index 1 Feature: appxk9
Period left: Not Activated
Period Used: 0 minute 0 second
License Type: EvalRightToUse
License State: Active, Not in Use, EULA not accepted
License Count: Non-Counted
License Priority: None
Index 2 Feature: securityk9
Period left: Not Activated
Period Used: 0 minute 0 second
License Type: EvalRightToUse
License State: Active, Not in Use, EULA not accepted
License Count: Non-Counted
License Priority: None
Index 3 Feature: ipbasek9
Period left: Life time
License Type: Permanent
License State: Active, In Use
License Count: Non-Counted
License Priority: Medium
Index 4 Feature: FoundationSuiteK9
Period left: Not Activated
Period Used: 0 minute 0 second
License Type: EvalRightToUse
License State: Active, Not in Use, EULA not accepted
License Count: Non-Counted
License Priority: None
Index 5 Feature: throughput
Period left: Not Activated
Period Used: 0 minute 0 second
License Type: EvalRightToUse
License State: Active, Not in Use, EULA not accepted
License Count: Non-Counted
License Priority: None
Index 6 Feature: internal_service
Index 9 Feature: hseck9
ISR-4221-V2#
