Hi I use two commands in Nexus7000, They are show mac address-table and show interface vlan 3. The output is like below. The output is different with regular switch. There are several vlan 3 related mac address there highlighted as below. My question is what the relation of these mac is ? Thank you.
Nexus02# sh mac address-table
Legend:
* - primary entry, G - Gateway MAC, (R) - Routed MAC, O - Overlay MAC
age - seconds since last seen,+ - primary entry using vPC Peer-Link
VLAN MAC Address Type age Secure NTFY Ports/SWID.SSID.LID
---------+-----------------+--------+---------+------+----+------------------
G 3 0000.0c9f.f003 static - F F sup-eth1(R)
G 4 0000.0c9f.f004 static - F F vPC Peer-Link(R)
G 33 0000.0c9f.f021 static - F F sup-eth1(R)
G 514 64a0.e73f.c0c1 static - F F vPC Peer-Link(R)
G 3 64a0.e73f.c0c1 static - F F vPC Peer-Link(R)
G 515 64a0.e73f.c0c1 static - F F vPC Peer-Link(R)
G 3 64a0.e741.a6c1 static - F F sup-eth1(R)
* 3 0007.7dcd.73a6 dynamic 60 F F Po813
* 3 e41f.13f1.975e dynamic 0 F F Eth8/22
* 3 e41f.13f1.9760 dynamic 30 F F Eth8/22
Nexus02# sh int vlan 3
Vlan3 is up, line protocol is up
Hardware is EtherSVI, address is 64a0.e741.a6c1
Description: Network Tools - 192.30.3.0/24
Internet Address is 192.30.3.2/24
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not supported
ARP type: ARPA
Last clearing of "show interface" counters never
