Tag: "interface_issues" - Cisco Community

Latest Tagged

Ignored packets are on the router due to traffic overload or faulty interface - ( ‎06-18-2009 04:02 PM )

by on

0 Replies 23952 Views

0 Replies

23952 Views

Alignment error counter increments due to a misconfiguration or physical layer issue - ( ‎06-22-2009 05:12 PM )

by on

0 Replies 24424 Views

0 Replies

24424 Views

Cannot configure dot1Q encapsulation on a trunk port in the WS-X6148-GE-TX module - ( ‎06-22-2009 05:08 PM )

by on

0 Replies 3121 Views

0 Replies

3121 Views

Serial connection problems, including interface and line protocol status, output drops, input drops,... - ( ‎06-22-2009 05:27 PM )

by on

0 Replies 1524 Views

0 Replies

1524 Views

The VLAN interface is down, even though the "no shutdown" command is issued on the Cisco Catalyst 45... - ( ‎06-22-2009 05:07 PM )

by on

0 Replies 45753 Views

0 Replies

45753 Views

How to find the port Uptime/Downtime status or utilization in Catalyst 3750 series switches that run... - ( ‎06-22-2009 06:17 PM )

by on Latest post on by

1 Replies 112761 Views

1 Replies

112761 Views

Input errors on the Layer-3 interface of Catalyst 6500 switch running Cisco IOS when connected to th... - ( ‎07-01-2009 04:57 AM )

by on

0 Replies 3276 Views

0 Replies

3276 Views

The Gigabit Ethernet port does not work on Catalyst 2960 series switches and the "Failed PortPhiLoop... - ( ‎06-18-2009 03:50 PM )

by on

0 Replies 5117 Views

0 Replies

5117 Views

Ethernet media problems - excessive noise, excessive collisions, excessive runt frames, late collisi... - ( ‎06-22-2009 05:05 PM )

by on

0 Replies 2441 Views

0 Replies

2441 Views

Unable to configure clocking on a 7200 router that uses the PA-A3-8T1IMA port adapter - ( ‎06-22-2009 05:05 PM )

by on

0 Replies 1628 Views

0 Replies

1628 Views

Top Tagged

No link to an Ethernet device - ( ‎06-22-2009 06:12 PM )

by on

0 Replies 1879 Views

0 Replies

1879 Views

The "%MSFC2-3-TOOBIG: Attempt to send giant packet" error message is received on a Cisco Catalyst 65... - ( ‎06-22-2009 06:06 PM )

by on

0 Replies 3323 Views

0 Replies

3323 Views

How to run GOLD diagnostic tests on Catalyst 6500/6000 series switches to troubleshoot hardware issu... - ( ‎06-22-2009 05:38 PM )

by on

0 Replies 19629 Views

0 Replies

19629 Views

Interfaces are down and unable to establish the connection in Catalyst 6500 or 7600 Series Switches ... - ( ‎06-22-2009 05:38 PM )

by on

0 Replies 1464 Views

0 Replies

1464 Views

The %PHY-4-EXCESSIVE_ERRORS: Excessive FCS, data, or idle word errors found on interface [chars]erro... - ( ‎06-22-2009 03:37 PM )

by on

0 Replies 17218 Views

0 Replies

17218 Views

User experiences FCS-err counter increments on a port due to a duplex configuration or hardware prob... - ( ‎06-22-2009 03:35 PM )

by on Latest post on by

4 Replies 67453 Views

4 Replies

67453 Views

Cannot autonegotiate port speed and duplex due to port configuration or NIC driver capability - ( ‎06-22-2009 05:28 PM )

by on

0 Replies 8683 Views

0 Replies

8683 Views

Serial connection problems, including interface and line protocol status, output drops, input drops,... - ( ‎06-22-2009 05:27 PM )

by on

0 Replies 1524 Views

0 Replies

1524 Views

Alignment error counter increments due to a misconfiguration or physical layer issue - ( ‎06-22-2009 05:12 PM )

by on

0 Replies 24424 Views

0 Replies

24424 Views

Ignored packets are on the router due to traffic overload or faulty interface - ( ‎06-18-2009 04:02 PM )

by on

0 Replies 23952 Views

0 Replies

23952 Views

Top Taggers

User

Count