Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have some Mobility Express deployments that are managed through Prime Infrastructure. Occasionally I am getting alarms such as the following logged in PI:Maximum client limit '20' reached on interface '802.11a/b/g/n/ac' of AP 'wrcsap25'.
Maximum cl...
This is probably/hopefully something simple, but I'm beating my head here. I can ping stuff on the internet, surf websites, etc., but can't traceroute (every hop times out).I've stripped things down to a very basic config (below) to help troubleshoot...
I have also experienced the same problem with Intel AX201, Intel AC7260 and Qualcomm QCA61x4A. The problem exists in Windows 10 feature version 2004, 20H2 and 21H1. Earlier versions of Windows 10 (<=1909) work fine.Microsoft finally fixed it in KB500...
Replying to an old thread since the current "accepted solution" does not answer the question. You can achieve what OP was asking for via the CLI command 11n-client-only:config rf-profile 11n-client-only enable PROFILENAME
If the client truly insists on having a terrible design with 14 completely independent SSIDs for every access point, then I think it would be better to just give them 14 independent standalone access points. Instead of trying to make an expensive uni...
(Cisco Controller) >config 802.11-abgn band ap VNSGNB09AP 5GHzRadio [Slot 0] does not have external antenna plugged into a DART Connector Dual 5GHz Operation Not AllowedThe 2800/3800 APs have two separate radios - a 5 GHz radio, and also a dual-band ...
Looks like Cisco has apparently added this gem to the release notes at some point:If there are more than 25 Access Points in a Mobility Express network, the Master AP(running the Wireless LAN controller function) can service a maximum of 20 clients. ...
