cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1113
Views
5
Helpful
0
Replies

Can't Access UWM

zgafford
Beginner
Beginner

Hi all,

I have been searching, but can't seem to find an answer to a problem I have.

I have loaded the 5 interface OVA file on an ESXi host and followed the setup guide, but I am unable to access the UWM. Running virl_setup, I have the primary interface set to eth0 and it is set to a static IP.

While running through the troubleshooting steps listed here (T-Shoot: UWM admin page unavailable; error: "unable to connect" - 31607 - The Cisco Learning Network) I noticed when I run grep -E '^internalnet_' /etc/virl.ini the internalnet_port is set to eth4 instead of eth0.

Even after rerunning virl_setup and selecting eth0 as the primary interface, internalnet_port is stuck at eth4.

How can I update the ports so I am able to access UWM?

I am running virl.5i.1.3.296.esxi.ova

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers