i have configured the firewall to lease dhcp ip, created vlan, qos.
The configuration done on the switch are only
Switch(config)# int gi6
Switch(config-if)#switchport mode access
Switch(config-if)#switchport access vlan 10
But still the Gi6 port ...
This is a simple qos configuration. I want remark it using the dscp command (ie: where to specify set ip dhcp command and match ip dscp command) .
The intention here is to limit the bandwidth using shape command and if it exceeds then must be dropped...
I have a 3925 cisco router which is connected to SG 350 Semi manageable switch. I have an isp with 200 Mbps connection. I want port 3 of switch to get 20 Mbps only. Port 3 is in vlan 20. I have done till this onlyRouterint gig0/0ip address 192.168.52...
Here in the diagram below i should be able to do all communication from PC1 to the webserver using only NAT/PAT Concepts, but without using any of the routing protocols.
So you are saying that there no other additional configurations required for the switch. Actually the port from firewall to switch's port is truncated.